Advanced Microcontroller Lab

1.To demonstrate the procedure for flash programming for reprogrammable embedded system board using NXP’s FlashMagic.

2.To demonstrate the procedure of flash programming source code for reprogrammable embedded system board using Sunrom technology’s 89SXX USB flash programmer, ISP Model.

3.To demonstrate the procedure and connections for multiple controllers programming of same type of controller with same source code in one go, using flash magic.

4.To interface 8 LEDs at Input-output port and create different patterns.

5.To demonstrate use of general purpose port i.e. Input/ output port of two controllers for data transfer between them.

6.To demonstrate block wise programming of memory for micro controller using flash magic.

7.To demonstrate block wise erasing of memory for micro controller using flash magic.

8.To demonstrate timer working in timer mode and blink LED without using any loop delay routine.

9.To demonstrate interfacing of seven-segment LED display and generate counting from 0 to 99 with fixed time delay.

10.To demonstrate serial communication between PC and controller using serial UART of controller.

11.To demonstrate communication between two controllers using SPI in master mode. Only master will send and Slave will receive.

12.To demonstrate communication between two controllers using SPI in master and slave mode. Master will send, Slave will receive and vice versa.

13.To demonstrate interfacing of 16x2 LCD and print some welcome message on it.

ELECTIVE-III